Connect Procedure
WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Refer to Battery Disconnect Caution
.
IMPORTANT:
Clean any existing corrosion from the battery terminal and the battery cable end.
- Install the auxiliary negative battery cable onto the battery negative post.
- Tighten the auxiliary negative battery cable nut (1).
Tighten: Tighten the nut to 7.5 N.m (66 lb in).
- Close the auxiliary battery negative cable post cover.
- Install the primary negative battery cable onto the battery negative post.
- Tighten the primary negative battery cable nut (6).
Tighten: Tighten the nut to 5 N.m (44 lb in).
- Close the hood.
NOTE:
Refer to Fastener Notice
.