Diagnostic Aids
WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Be sure to rule out any possible obvious influences, such as customer error or aftermarket equipment. Anytime aftermarket accessories are installed into the courtesy lamp circuit, it can cause the inadvertent power timer in the body control module (BCM) to keep resetting. This would cause the BCM to remain awake and cause a current drain on the battery.
- Customer driving habits, such as regular short trips. This does not allow enough time to properly charge the battery. Refer to Battery Description and Operation .
- Verify that the battery and charging system are in proper working order. Refer to Battery Charging and Charging System Test .
- A battery discharging for no apparent reason while the vehicle is parked can be caused by an intermittent draw, such as a module waking up, or a continuous draw, such as a dome light or stuck relay.
- Some systems and modules such as OnStar®, and regulated voltage control (RVC), if equipped, are designed to wake-up, perform a task, and go back asleep at regular intervals. Refer to Body Control System Description and Operation for the system or modules description and operation.
- Remote keyless entry (RKE) will wake up due to an outside input. Refer to Keyless Entry System Description and Operation for the system description and operation.
- The battery run down time will vary depending on cold cranking amperage (CCA) and reserve capacity (RC). If the CCA and RC are higher, then the battery run down time would be longer. If the CCA and RC are lower, then the battery run down time would be shorter. The graph below indicates roughly how many days a 690 CCA battery with at 110 min. RC (60.5 AH) starting at 80 percent state of charge will last with a constant current draw until it reaches 50 percent state of charge. Differences in battery rating and temperature will affect the results.
IMPORTANT:
The battery specification listed below is a generic specification. Refer to Battery Usage when testing the battery.
Battery Electrical Drain/Parasitic Load Test
| Current Drain | Days |
|---|---|
| 25 mA | 30.5 |
| 50 mA | 16.5 |
| 75 mA | 11 |
| 100 mA | 8.25 |
| 250 mA | 3.3 |
| 500 mA | 1.65 |
| 750 mA | 1 |
| 1 A | 0.8 |
| 2 A | 0.4 |