Front Side Door Hinge Replacement
WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Front Side Door Hinge Replacement
| Callout | Component Name |
|---|---|
|
CAUTION:
Refer to SIR Caution
. Preliminary Procedure: Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling
. |
|
| 1 | Front Side Door Hinge Upper Bolt (Qty: 3)
NOTE:
Fastener Notice
. Tip: Replace only one hinge at a time. Tighten: 25 N.m (18 lb ft) |
| 2 | Front Side Door Hinge Upper Bolt (Qty: 3) Tighten: 25 N.m (18 lb ft) |
| 3 | Front Side Door Upper Hinge Tip: Check the door for proper alignment, then adjust as necessary. |
| 4 | Front Side Door Hinge Lower Bolt Tip: After installation of the replacement upper hinge, from the underside of the hinge, remove the temporary keeper pivot bolt and replace with longer permanent bolt. Tighten: 25 N.m (18 lb ft) |
| 5 | Front Side Door Hinge Lower Bolt (Qty: 3) Tighten: 25 N.m (18 lb ft) |
| 6 | Front Side Door Hinge Lower Bolt (Qty: 4) Tighten: 25 N.m (18 lb ft) |
| 7 | Front Side Door Lower Hinge Tip: Check the door for proper alignment, then adjust as necessary. |