Steering Wheel Position Sensor Replacement

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Steering Column Bracket, Bolts, Electrical Connector, Position Sensor & Position Sensor Clip

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
CAUTION: Refer to SIR Caution . Preliminary Procedure: Remove the steering column. Refer to Steering Column Replacement .
1	Steering Column Bracket Screw (Qty: 3) NOTE: Refer to Fastener Notice . Tighten: 6 N.m (53 lb in)
2	Steering Column Bracket
3	Steering Wheel Position Sensor Retaining Clip
4	Steering Wheel Position Sensor Procedure: Disconnect any electrical connectors as needed. Tip: When reusing a steering wheel position sensor, you must install a pin into the sensor before removal or the sensor will lose the centering position and must be discarded. The pin diameter must be in the range of 1-2 mm. A new steering wheel position sensor will come with a pin installed in the sensor. The steering wheel position sensor will already come centered, DO NOT remove the pin until the steering wheel position sensor is properly seated. During installation the steering wheel position sensor must be set with approximately 3 mm gap between the it and the bearing adapter.