LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 869 (Steering Wheel & Steering Column) >> Repair Instructions >> Automatic Transmission Control Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to SIR Caution .
  1. Remove the steering column. Refer to Steering Column Replacement .
  2. Remove the shift lever. Refer to Shift Lever Replacement .
    3. Fig 1: Identifying Park Lock Cable At Ignition Lock Cylinder
    GM324874Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: The ignition lock cylinder set should be in the OFF-LOCK position.
  3. Disconnect the automatic transmission park lock cable (1).
    4. Fig 2: View Of AT Shift Lock Control Actuator
    GM1858766Courtesy of GENERAL MOTORS CORP.
    NOTE: Do not use excessive force when removing the automatic transmission shift lock control from the steering column. Using excessive force may cause damage to the automatic transmission shift lock control and/or the steering column.
  4. Disconnect the automatic transmission shift lock control actuator (1) from the automatic transmission control.
    5. Fig 3: View Of AT Control & Bolts
    GM1858765Courtesy of GENERAL MOTORS CORP.
  5. Remove the automatic transmission control bolts (1).
  6. Remove the automatic transmission control (2).
scientia non olet · About LEMON Manuals