Air Temperature Actuator Replacement - Left Side

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Left Air Temp Actuator & Screws

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
NOTE: In order to avoid actuator damage, DO NOT apply power to the actuator when it is not installed in the HVAC module. Preliminary Procedure Remove the instrument panel insulator. Refer to Instrument Panel Insulator Replacement (Without RPO SLT) or Instrument Panel Insulator Replacement (with RPO SLT) . Disconnect the electrical connector from the air temp actuator.
1	Air Temp Actuator Screws (Qty: 2) NOTE: Refer to Fastener Notice . Tighten: 1.6 N.m (14 lb in)
2	Air Temp Actuator Procedure: Re-calibrate the air temp actuator. Refer to Actuator Recalibration .

Callout

Component Name

NOTE: In order to avoid actuator damage, DO NOT apply power to the actuator when it is not installed in the HVAC module.

Preliminary Procedure

Remove the instrument panel insulator. Refer to Instrument Panel Insulator Replacement (Without RPO SLT) or Instrument Panel Insulator Replacement (with RPO SLT) .
Disconnect the electrical connector from the air temp actuator.

Air Temp Actuator Screws (Qty: 2)

NOTE: Refer to Fastener Notice .

Tighten: 1.6 N.m (14 lb in)

Air Temp Actuator
Procedure:
Re-calibrate the air temp actuator. Refer to Actuator Recalibration .