LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 865 (Instrument Panel System Displays And Gauges) >> Diagnostic Information & Procedures >> Water-in-Fuel Lamp Always On >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the water in fuel sensor.
  2. Ignition OFF, test for less than 1.0 ohm of resistance between the ground circuit and ground.
    • If greater than 1.0 ohm, test the ground circuit for an open/high resistance.
  3. Verify the scan tool Water In Fuel Sensor parameter is No Water.
    • If not No Water, test the signal circuit of the water in fuel sensor for a short to ground. If the circuit tests normal, replace the ECM.
  4. If all circuits test normal, test or replace the water in fuel sensor.
scientia non olet · About LEMON Manuals