Installation Procedure
WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Install the new O-ring seal to the switch. Refer to O-Ring Replacement .
- Install the A/C low pressure switch to the accumulator.
Tighten: Tighten the switch to 6 N.m (53 lb in).
- Connect the electrical connector to the A/C low pressure switch.
- Leak test the fittings of the components using the J 39400-A . See Special Tools .
NOTE:
Refer to Fastener Notice
.