Parking Brake Shoe Replacement (JD9)

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Parking Brake Shoe (JD9)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
CAUTION: Refer to Brake Dust Caution . Preliminary Procedures Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Remove the brake rotor. Refer to Rear Brake Rotor Replacement (JD9) or Rear Brake Rotor Replacement (JH6, JH7) . Disconnect the park brake cable from the actuator.
1	Park Brake Shoe Retaining Clip Bolt (Qty: 2) NOTE: Refer to Fastener Notice . Tighten: 15 N.m (11 lb ft)
2	Park Brake Shoe Retaining Clip (Qty: 2)
3	Park Brake Shoe and Lining Procedure To remove and install the park brake shoe, place the open end of the park brake shoe over the axle flange and rotate it until the shoe has cleared the flange. Apply a thin coat of high temperature silicone brake lubricant to the contact areas of the brake shoe and the backing plate. Adjust the park brake. Refer to Park Brake Adjustment (Disc Brake) or Park Brake Adjustment (Drum Brake) .