LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 863 (Parking Brake System) >> Repair Instructions >> Parking Brake Rear Cable Replacement - Right Side (JH6, JH7) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Right Brake Rear Cable Replacement
    GM1862965Courtesy of GENERAL MOTORS CORP.
  1. Release the park brake.
  2. Disable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Disabling .
  3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  4. Disconnect the right park brake cable from the equalizer (1).
  5. Release the right park brake cable from the frame bracket by compressing the locking tabs on the cable conduit (2) and pulling the cable rearward.
    6. Fig 2: Park Brake Cable Mounting
    GM1862968Courtesy of GENERAL MOTORS CORP.
  6. Release the park brake cable (1) from the rear axle housing cover clip.
  7. Remove the park brake cable clip bolt (2).
    8. Fig 3: Park Brake Cable Eye And Park Brake Actuator Lever
    GM1862970Courtesy of GENERAL MOTORS CORP.
  8. Disconnect the park brake cable eye (3) from the park brake actuator lever (2).
  9. Remove the park brake cable from the bracket by pulling the cable conduit (1) rearward to compress the spring and sliding the cable conduit out of the bracket.
  10. Remove the park brake cable assembly from the vehicle.
scientia non olet · About LEMON Manuals