Installation Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Park Brake Cable

Courtesy of GENERAL MOTORS CORP.

Install the park brake cable to the vehicle.
Install the brake shoes. Refer to Brake Shoe Replacement .
Ensure the locking tabs on the cable conduit are fully engaged into the rear axle bracket.

Fig 2: Park Brake Cable Mounting

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the park brake cable clip bolt (2).
Tighten: Tighten the bolt to 22 N.m (16 lb ft).
Connect the park brake cable (1) to the rear axle housing cover clip.
Install the park brake cable to the cable guides.

Fig 3: Right Parking Brake Rear Cable

Courtesy of GENERAL MOTORS CORP.

Connect the right rear park brake cable (1) to the intermediate cable equalizer bar (2).
Insert the park brake cable conduit (3) into the frame bracket.
Ensure the locking tabs on the cable conduit are fully engaged into the frame bracket.
Enable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Enabling .
Adjust the park brake. Refer to Park Brake Adjustment (Disc Brake) or Park Brake Adjustment (Drum Brake) .