LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 863 (Parking Brake System) >> Repair Instructions >> Parking Brake Rear Cable Replacement - Right Side (JD9) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Right Park Brake Cable And Intermediate Cable Equalizer Bar
    GM1850956Courtesy of GENERAL MOTORS CORP.
  1. Release the park brake.
  2. Disable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Disabling .
  3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  4. Disconnect the right park brake cable (1) from the intermediate cable equalizer bar (2).
  5. Release the right park brake cable from the frame bracket by compressing the locking tabs and pulling the cable conduit (3) rearward.
    6. Fig 2: Park Brake Cable Mounting
    GM1850957Courtesy of GENERAL MOTORS CORP.
  6. Release the park brake cable (1) from the rear axle housing cover clip.
  7. Remove the park brake cable clip bolt (2).
    8. Fig 3: Park Brake Cable Conduit And Park Brake Cable Eye
    GM1850958Courtesy of GENERAL MOTORS CORP.
  8. Release the park brake cable from the rear axle bracket by compressing the locking tabs and pulling the park brake cable conduit (1) rearward.
  9. Disconnect the park brake cable eye (2) from the park brake actuator lever.
  10. Remove the park brake cable assembly from the vehicle.
scientia non olet · About LEMON Manuals