LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 863 (Parking Brake System) >> Repair Instructions >> Parking Brake Rear Cable Replacement - Left Side (JF3, JF7) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Left Park Brake Cable And Intermediate Cable Equalizer Bar
    GM1850953Courtesy of GENERAL MOTORS CORP.
  1. Release the park brake.
  2. Disable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Disabling .
  3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  4. Disconnect the left park brake cable (1) from the intermediate cable equalizer bar (2).
  5. Release the left park brake cable from the frame bracket by compressing the locking tabs and pulling the cable conduit (3) rearward.
  6. Remove the park brake cable from the cable guides.
    7. Fig 2: View Of J 37043
    GM1276848Courtesy of GENERAL MOTORS CORP.
  7. Remove the brake shoes. Refer to Brake Shoe Replacement .
  8. Using the J 37043  (1), remove the park brake cable from the backing plate. See Special Tools .
    9. Fig 3: View Of Left Park Brake Cable
    GM1306858Courtesy of GENERAL MOTORS CORP.
  9. Remove the park brake cable assembly from the vehicle.
scientia non olet · About LEMON Manuals