LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 863 (Parking Brake System) >> Repair Instructions >> Parking Brake Intermediate Cable Replacement (JH6, JH7) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Front Park Brake Cable And Intermediate Cable Connector
    GM1862950Courtesy of GENERAL MOTORS CORP.
  1. Release the park brake.
  2. Disable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Disabling .
  3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  4. Disconnect the front park brake cable (2) from the intermediate cable connector (1) by drilling a 3 mm (1/8 in) hole through the dimple in the front to intermediate park brake cable connector.
    5. Fig 2: Left Park Brake Cable And Intermediate Cable Connector
    GM1862951Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the left park brake cable (2) from the intermediate cable connector (1) by drilling a 3 mm (1/8 in) hole through the dimple in the front to intermediate park brake cable connector.
  6. Remove the intermediate park brake cable.
scientia non olet · About LEMON Manuals