LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 862 (Engine Cooling System) >> Repair Instructions >> Turbocharger Coolant Bypass Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Turbocharger Bypass Valve & Washer
    GM687052Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the turbocharger bypass valve and washer.

    Tighten:  Tighten the valve to 60 N.m (44 lb ft).

    2. Fig 2: View Of Turbocharger Coolant Inlet Hose
    GM1874052Courtesy of GENERAL MOTORS CORP.
  2. Connect the turbocharger coolant inlet hose to the turbocharger bypass valve.
  3. Position the coolant inlet hose clamp.
  4. Fill the cooling system. Refer to Cooling System Draining and Filling (Static Fill)  or Cooling System Draining and Filling (Vac-N-Fill) .
  5. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
scientia non olet · About LEMON Manuals