Rear Spoiler Replacement (901/902)

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Spoiler (901/902)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Endgate Spoiler Assembly Screws (Qty: 4) NOTE: Refer to Fastener Notice . Tighten: 10 N.m (89 lb in)
2	Endgate Spoiler Assembly Locator Pin
3	Endgate Spoiler Assembly Adhesive Tape Liner Tip: The part and surface should be ambient temperature prior to installation. The vehicle should remain ambient temperature for one hour after assembly to allow adhesive to develop sufficient bond strength. Release the liner and wet out once the endgate spoiler is in position and the screws have been installed.
4	Endgate Spoiler Assembly
5	Endgate Spoiler Assembly Riv-nuts (Qty: 4)