Hood Rear Molding Replacement (Chevrolet HD)

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Hood Rear Molding (Chevrolet HD)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Hood Rear Molding Screw (Qty: 2) NOTE: Refer to Fastener Notice . Tighten:: 1.5 N.m (13 lb in)
2	Hood Rear Molding Assembly Nut (Qty: 2)
3	Hood Rear Molding Integral Clip (Qty: 4) Tip: Ensure all four clips are fully seated prior to installing the hood rear molding screws.
4	Hood Rear Molding Tip: Gently pry the hood molding upward, in order to remove.