Tail Lamp Replacement (GMC)

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Tail Lamp (GMC)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Open the endgate in order to access the tail lamp assembly screws. Disconnect the electrical harness to the tail lamp.
1	Tail Lamp Assembly Screws (Qty: 2) NOTE: Refer to Fastener Notice . Tighten: 2 N.m (18 lb in)
2	Tail Lamp Assembly Tip: Upon installation, push inward on the outer edge of the tail lamp in order to seat the 2 locating pins in the body panel.

Callout

Component Name

Preliminary Procedures

Open the endgate in order to access the tail lamp assembly screws.
Disconnect the electrical harness to the tail lamp.

Tail Lamp Assembly Screws (Qty: 2)

NOTE: Refer to Fastener Notice .

Tighten: 2 N.m (18 lb in)

Tail Lamp Assembly
Tip: Upon installation, push inward on the outer edge of the tail lamp in order to seat the 2 locating pins in the body panel.