Front Fog Lamp Replacement (Chevrolet)

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Front Fog Lamp (Chevrolet)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove either the LF or RF wheelhouse liners. Refer to Front Wheelhouse Liner Replacement - Left Side (Chevrolet) or Front Wheelhouse Liner Replacement - Left Side (GMC) for the LF or Front Wheelhouse Liner Replacement - Right Side (Chevrolet) or Front Wheelhouse Liner Replacement - Right Side (GMC) for the RF wheelhouse liner. Disconnect the electrical connector. From inside the from bumper fascia, using a blunt instrument, pinch the retainers and push outward on the 2 upper mounting studs for the fog lamp. Using the same blunt instrument, pinch the retainer and push outward on the lower adjustment screw for the fog lamp. Aim the fog lamps after the fog lamp has been replaced. Refer to Fog Lamp Aiming .
1	Fog Lamp Retainers (Qty: 3) Tip: Re-install the retainers back into the fascia prior to installing the lamp assembly.
2	Fog Lamp Assembly Tip: Transfer the bulb assembly as needed.

Callout

Component Name

Preliminary Procedures

Remove either the LF or RF wheelhouse liners. Refer to Front Wheelhouse Liner Replacement - Left Side (Chevrolet) or Front Wheelhouse Liner Replacement - Left Side (GMC) for the LF or Front Wheelhouse Liner Replacement - Right Side (Chevrolet) or Front Wheelhouse Liner Replacement - Right Side (GMC) for the RF wheelhouse liner.
Disconnect the electrical connector.
From inside the from bumper fascia, using a blunt instrument, pinch the retainers and push outward on the 2 upper mounting studs for the fog lamp.
Using the same blunt instrument, pinch the retainer and push outward on the lower adjustment screw for the fog lamp.
Aim the fog lamps after the fog lamp has been replaced. Refer to Fog Lamp Aiming .

Fog Lamp Retainers (Qty: 3)
Tip: Re-install the retainers back into the fascia prior to installing the lamp assembly.

Fog Lamp Assembly
Tip: Transfer the bulb assembly as needed.