LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 859 (Lighting Systems) >> Diagnostic Information and Procedures >> High Beam Indicator Inoperative

High Beam Indicator Inoperative

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
High Beam Indicator Inoperative

Step Action Yes No
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle
2
  1. Turn the ignition switch to the RUN position.
  2. Turn the headlamp switch to the ON position.
  3. Place the multifunction headlamp dimmer switch to the high beams position.
Do the high beam indicator function properly?		 Go to Testing for Intermittent Conditions and Poor Connections Go to Step 3 
3 Do the high beam headlamps function properly? Go to Step 4  Go to Symptoms - Lighting 
4 Inspect for poor connections at the harness connector of the instrument panel cluster (IPC). Refer to Circuit Testing and Wiring Repairs .
Did you find and correct the condition?		 Go to Step 6  Go to Step 5 
5 Replace the IPC. Refer to Control Module References for replacement, setup, and programming.
Did you complete the replacement?		 Go to Step 6  -
6 Operate the system in order to verify the repair.
Did you correct the condition?		 System OK Go to Step 3 
scientia non olet · About LEMON Manuals