LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 858 (Sunroof System) >> Repair Instructions >> Sunroof Sunshade Replacement (Crew Cab) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Track Slot, Retaining Tabs And Sunshade
    GM757742Courtesy of GENERAL MOTORS CORP.
  1. Position the sunshade to the vehicle from the top of the vehicle.
  2. Install the retaining tabs on the far side of the sunshade, starting with the center tab first in the track slot of the sunroof.
  3. Flex the center of the sunshade (2) upwards while simultaneously inserting the retaining tabs (3) into the track slot (1).
  4. Ensure that the sunshade tabs are fully seated in the track slots, and the sunshade slides smoothly.
    5. Fig 2: Sunroof Assembly Retaining Screw
    GM594496Courtesy of GENERAL MOTORS CORP.
  5. Install the water trough to the sunroof from the top of the vehicle.
    6. NOTE: Refer to Fastener Notice .
  6. Install the screws (1) that retain the water trough to the sunroof.

    Tighten:  Tighten the screws to 1 N.m (9 lb in).

  7. Install the sunroof window. Refer to Sunroof Window Replacement (Crew Cab)  or Sunroof Window Replacement (Extended Cab) .
scientia non olet · About LEMON Manuals