Inflatable Restraint Front End Sensor Replacement (2500, 3500)

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Inflatable Restraint Front End Sensor & Bolt

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
CAUTION: Do not strike or jolt the inflatable restraint front end sensor. Before applying power to the front end sensor make sure that it is securely fastened. Failure to observe the correct installation procedure could cause SIR deployment, personal injury, or unnecessary SIR system repairs. Preliminary Procedure: Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling .
1	Supplemental Inflatable Restraint Front End Discriminating Sensor Bolt (Qty: 1) NOTE: Refer to Fastener Notice . Tip: Loosen bolt in order to remove sensor. Tighten: 8 N.m (71 lb in)
2	Supplemental Inflatable Restraint Front End Discriminating Sensor Assembly Tip: Remove connector position assurance (CPA) retainer. Disconnect electrical connector.