LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 855 (Supplemental Inflatable Restraint System) >> Diagnostic Information and Procedures >> DTC B1370 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2007 GMC Sierra and 2007 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    IMPORTANT: When removing connectors, inspect for damage or corrosion. Damage or corrosion in the following requires repair or replacement of the affected component/connector:
    • The SDM module
    • The SDM wiring harness connector
  1. Ignition OFF, remove the Air Bag fuse from the underhood fuse center. Ignition ON, engine OFF test the voltage from the supply voltage side of the AIR BAG fuse to a ground with a DMM. The voltage should read 9-16 volts.
    • If the voltage is less than 9-16 volts, refer to DTC B1370 .
  2. Remove the SDM connector.
  3. With the Air Bag fuse removed, test the ignition 1 voltage circuit between the underhood fuse center and the SDM for a short to voltage or an open. Verify that a short to voltage or an open does not exist.
    • If any of the above conditions are found, make the appropriate repair.
  4. If all circuits test normal, replace the SDM.
scientia non olet · About LEMON Manuals