LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 255 (Exterior Trim) >> Repair Instructions >> Molding Replacement - Rocker Panel (Luxury Y91) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the push pin retainers from the bottom of the rocker panel molding.
  2. Tilt the lower portion of the rocker panel molding out away from the vehicle.
  3. In order to remove the rocker panel molding from the vehicle, carefully lift up the molding.
    Fig 1: Removing Rocker Panel Molding (Luxury Y91)
    G02422794Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals