Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
Important: In order to install the rocker panel molding to the retaining channel, pull the lower portion of the rocker panel molding away from the vehicle.
- Install the rocker panel molding to the vehicle.
Important: Press the rocker panel molding completely into the channel in order to remove any air gaps.
- Install the push pin retainers. Gently push up on the rocker panel molding until the rocker panel molding is flush with the metal retaining-channel.