Removal Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
Important: Use the tape for protection and alignment marks for alignment of the new emblem.
- Apply tape to the area around the door emblem.
- Heat the emblem/nameplate, using a heat gun J 25070 152 mm (6.0 in) from the surface.
- Apply the heat using a circular motion for about 30 seconds.CAUTION: Use a plastic, flat-bladed tool to prevent paint damage when removing an emblem/name plate.
- Remove the emblem/nameplate from the door surface using a plastic, flat-bladed tool.
- Remove all adhesive from the door panel surface and the back of the emblem/nameplate using 3M™ Scotch Brite Molding Adhesive Remover Disk 3M™ P/N 07501 or equivalent.
- Clean the door surface using varnish makers and painters (VMP) naptha.