LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 252 (Seat Belt System) >> Repair Instructions >> Seat Belt Height Adjuster Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the shoulder/seat belt guide adjuster to the vehicle.
    CAUTION: Refer to FASTENER NOTICE .
  2. Install the shoulder/seat belt guide adjuster retaining bolts to the pillar.

    Tighten 

    Tighten the shoulder/seat belt guide adjuster retaining bolts to 52 N.m (38 lb ft).

    Fig 1: Installing Shoulder/Seat Belt Guide Adjuster
    G02423707Courtesy of GENERAL MOTORS CORP.
  3. Install the shoulder/seat belt guide to the guide adjuster.
  4. Install the shoulder/seat belt guide retaining bolt to the guide adjuster.

    Tighten 

    Tighten the shoulder/seat belt guide retaining bolt to 52 N.m (38 lb ft).

  5. Install the front door upper pillar garnish molding. Refer to GARNISH MOLDING REPLACEMENT - UPPER PILLAR .
    Fig 2: Installing Shoulder/Seat Belt Guide
    G02423708Courtesy of GENERAL MOTORS CORP.
  6. Install the shoulder/seat belt guide to the guide adjuster cover (1).
    Fig 3: Installing Shoulder/Seat Belt Guide To Guide Adjuster Cover
    G02423709Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals