Noise and Vibration Analysis
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
A noise or vibration that is noticeable when the vehicle is in motion MAY NOT be the result of the transmission.
If noise or vibration is noticeable in PARK and NEUTRAL with the engine at idle, but is less noticeable as RPM increases, the cause may be from poor engine performance.
- Inspect the tire for the following:
- Uneven wear
- Imbalance
- Mixed sizes
- Mixed radial and bias ply
- Inspect the suspension components for the following:
- Alignment and wear
- Loose fasteners
- Inspect the engine and transmission mounts for damage and loose bolts.
- Inspect the transmission case mounting holes for the following:
- Missing bolts, nuts, and studs
- Stripped threads
- Cracks
- Inspect the flywheel for the following:
- Missing or loose bolts
- Cracks
- Imbalance
- Inspect the torque converter for the following:
- Missing or loose bolts or lugs
- Missing or loose balance weights
- Imbalance