LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 236 (Automatic Transmission - 4L60-E/4L65-E (Service & Replacement)) >> Repair Instructions >> 2-4 Servo >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2003 GMC Savana and 2003 Chevrolet Chevy Express. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the new seals on the pistons and the servo cover.
  2. Lubricate the seals with clean transmission fluid.
  3. Install the 2-4 servo assembly into the 2-4 servo bore.
  4. Install the servo cover and O-ring seal.
  5. Install the J 29714-A  .
    Fig 1: Installing 2-4 Servo Assembly
    G02424165Courtesy of GENERAL MOTORS CORP.
  6. Tighten the bolt on the J 29714-A  in order to compress the servo cover.
  7. Install the servo cover retaining ring.
  8. Remove the J 29714-A  from the oil pan flange.
    CAUTION: Refer to FASTENER NOTICE .
  9. Install the oil pan bolt.

    Tighten 

    Tighten the oil pan bolt to 11 N.m (97 lb in).

  10. Install the 2 heat shield retaining bolts and the heat shield from the transmission.

    Tighten 

    Tighten the bolts to 17 N.m (13 lb ft).

  11. Lower the vehicle.
  12. Fill the transmission to the proper level with approved fluid.
    Fig 2: Tightening Bolt On J 29714-A
    G02424166Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals