LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 234 (Seat System) >> Repair Instructions >> Seat Cushion Frame Replacement - Rear >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the seat cushion frame.
    Fig 1: Installing Rear Seat Cushion Frame
    G02423310Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to FASTENER NOTICE .
  2. Install the bolts that retain the seat back hinges to the seat cushion frame in the locations noted during disassembly.

    Tighten 

    Tighten the bolts to 30 N.m (22 lb ft).

    3. Fig 2: Installing Seat Back Hinges To Seat Cushion Frame Bolts
    G02423311Courtesy of GENERAL MOTORS CORP.
  3. Install the lower anchor bolt for the center seat belt retractor, if equipped. Refer to SEAT BELT REPLACEMENT - CENTER REAR .
  4. Install the seat belt buckles. Refer to SEAT BELT BUCKLE REPLACEMENT - FRONT .
  5. Install the seat cushion cover and pad. Refer to Seat Cushion Cover and Pad Replacement - Rear .
  6. Install the rear seat into the vehicle. Refer to Seat Replacement - Rear Bench .
scientia non olet · About LEMON Manuals