Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
Important: The shift lever seal must be installed to the narrow end of the shift lever.
- Install the shift lever seal (2) onto the shift lever assembly (4).
- Install the shift lever assembly (4).CAUTION: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
- Install the shift lever screw (3) into the shift lever assembly (4).
Tighten
Tighten the screw to 1.5 N.m (13 lb in).
- Slide the shift lever seal (2) down the shift lever assembly (4).
- Align the shift lever seal into the steering column trim covers.
- If necessary, install the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
- Enable the SIR system. Refer to ZONE 3 .