LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 221 (Steering Wheel & Steering Column) >> Repair Instructions >> Lower Bearing And Steering Column Jacket Replacement (Column Shift Standard) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disable the SIR system. Refer to ZONE 3 .
  2. Remove the shift lever assembly. Refer to Shift Lever Replacement .
  3. Remove the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement .
  4. Remove the ignition lock cylinder case. Refer to Ignition Lock Cylinder Case Replacement (Floor Shift)  or Ignition Lock Cylinder Case Replacement (Column Shift)  .
  5. Inspect the steering column for accident damage. Refer to Steering Column Accident Damage Inspection .
  6. Remove the 2 pan head tapping screws from the turn signal and multifunction switch assembly. Remove the turn signal and multifunction switch assembly.
    Fig 1: Removing Turn Signal & Multifunction Switch Assembly
    G01217436Courtesy of GENERAL MOTORS CORP.
    CAUTION: Do not use excessive force when removing the automatic transmission shift lock control from the steering column. Using excessive force may cause damage to the automatic transmission shift lock control and/or the steering column.
  7. Remove the A/T shift lock control in the following way:
    1. Put the shift lever clevis into the NEUTRAL position.
    2. Use a small screwdriver to pry the A/T shift lock control away from the steering column jacket assembly and the cable shift cam assembly.
  8. Remove the linear shift assembly. Refer to Linear Shift Assembly Replacement .
    Fig 2: Removing A/T Shift Lock Control
    G01217437Courtesy of GENERAL MOTORS CORP.
  9. Remove the inner boot seal (4).
  10. Remove the steering shaft seal (3) from the adapter and bearing assembly (1).
  11. Remove the shaft seal retainer (2) from the adapter and bearing assembly (1).
  12. Remove the adapter and bearing assembly (1) from the steering shaft assembly.
    Fig 3: Removing Adapter & Bearing Assembly & Components From Steering Shaft Assembly
    G01217438Courtesy of GENERAL MOTORS CORP.
  13. Remove the steering shaft assembly (1) from the steering column support assembly (2) and the steering column jacket assembly (3).
    Fig 4: Removing Steering Shaft Assembly From Steering Column Support Assembly & Steering Column Jacket Assembly
    G01217439Courtesy of GENERAL MOTORS CORP.
  14. Remove the 4 TORX® head screws (1) from the support assembly (2).
  15. Discard the 4 TORX® head screws (1).
  16. Remove the support assembly (2) from the jacket assembly (3).
    Fig 5: Removing Support Assembly From Jacket Assembly
    G01217440Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals