LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 217 (Antilock Brake System) >> Repair Instructions >> Wheel Speed Sensor Replacement (2WD) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
  2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels .
  3. Remove the brake rotor (2) shown on the 1500 series. Refer to REMOVAL (FRONT) .
    Fig 1: Removing Brake Rotor
    G01216217Courtesy of GENERAL MOTORS CORP.
  4. Remove the wheel speed sensor (WSS) mounting bolt.
    Fig 2: Removing Wheel Speed Sensor Mounting Bolt
    G01216218Courtesy of GENERAL MOTORS CORP.
    NOTE: Carefully remove the sensor by pulling it straight out of the bore. DO NOT use a screwdriver, or other device to pry the sensor out of the bore. Prying will cause the sensor body to break off in the bore.
  5. Remove the wheel speed sensor (5) from the hub/bearing assembly (4) shown on the 2500/3500 series.
    Fig 3: Removing Wheel Speed Sensor From Hub/Bearing Assembly
    G01216219Courtesy of GENERAL MOTORS CORP.
  6. Remove the WSS cable mounting clip from the knuckle.
  7. Remove the WSS cable mounting clip from the upper control arm.
  8. Remove the WSS cable mounting clip from the frame attachment point.
  9. Remove the WSS cable electrical connector.
    Fig 4: Removing Wheel Speed Sensor Cable Mounting Clips
    G01216220Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals