LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 217 (Antilock Brake System) >> Repair Instructions >> Battery Negative Cable Disconnect/Connect Procedure >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn off all the lamps and accessories.
  2. Turn the ignition OFF.
    WARNING: Before servicing any electrical component, the ignition key must be in the OFF or LOCK position and all electrical loads must be OFF, unless instructed otherwise in these procedures. If a tool or equipment could easily come in contact with a live exposed electrical terminal, also disconnect the negative battery cable. Failure to follow these precautions may cause personal injury and/or damage to the vehicle or its components.
  3. Remove the battery ground (negative) cable and bolt from the battery. See Fig 1.
    Fig 1: Removing Negative Battery Ground Cable & Bolt From Battery
    G00377180Courtesy of GENERAL MOTORS CORP.
  4. Remove the battery ground (negative) cable and bolt from the battery for auxiliary battery. See Fig 2.
Fig 2: Removing Negative Battery Ground Cable & Bolt From Battery For Auxiliary Battery
G00377181Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals