Installation Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2012 GMC Yukon XL, 2012 GMC Yukon, 2012 Chevrolet Tahoe, 2012 Chevrolet Suburban, and 2012 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of CMP Actuator Solenoid Valve

Courtesy of GENERAL MOTORS COMPANY

Install a NEW CMP actuator solenoid valve (234).
With the CMP actuator properly positioned onto the camshaft, the CMP actuator solenoid valve can be threaded completely into the camshaft using light hand pressure. Tighten by hand until snug.

Fig 2: Tightening CMP Actuator Solenoid Valve

Courtesy of GENERAL MOTORS COMPANY

Tighten the CMP actuator solenoid valve.
1. Tighten the CMP actuator solenoid valve a first pass to 65 N.m (48 lb ft).
2. Tighten the CMP actuator solenoid valve a final pass an additional 90 degrees using the J 45059 meter.

Fig 3: View Of Special Tool & Bolts

Courtesy of GENERAL MOTORS COMPANY

Remove the J 42386-A holding tool (1).
Install the CMP actuator magnet. Refer to Camshaft Position Actuator Magnet Replacement .
Install the starter. Refer to Starter Replacement .