Master Cylinder: Installation
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
- Install the master cylinder reservoir. See MASTER CYLINDER RESERVOIR . Bench bleed the master cylinder. See MASTER CYLINDER BENCH BLEEDING under BLEEDING, FILLING & FLUSHING BRAKE SYSTEM.
- Install the master cylinder to the vehicle. Install the master cylinder mounting nuts and tighten to specifications. See TORQUE SPECIFICATIONS .
- Remove the rubber cap or plug from the exposed brake pipe fitting ends. Connect the brake pipes. Tighten to specifications. See TORQUE SPECIFICATIONS .
- Connect the electrical connector to the brake fluid level sensor. Install the driver side upper fender support. Bleed the hydraulic brake system. See MANUAL BLEEDING under BLEEDING, FILLING & FLUSHING BRAKE SYSTEM. Release the park brake and unblock the wheels.