Removal (Front)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
- Inspect the brake fluid level in the brake master cylinder reservoir.
- If the brake fluid is midway between the maximum-full point and the minimum allowable level, no brake fluid needs to be removed from the reservoir before proceeding.
- If the brake fluid level is higher than midway between the maximum-full point and the minimum allowable level, remove the brake fluid with appropriate tool to the midway point before proceeding.
- Raise the vehicle. Remove the tire and wheel assembly. Inspect the caliper operation. See BRAKE CALIPER INSPECTION in DISC BRAKE SYSTEM under ADJUSTMENTS & INSPECTIONS.
- Remove the caliper from the mounting bracket and support the caliper with heavy mechanic's wire or equivalent. DO NOT disconnect the hydraulic brake flexible hose from the caliper. See BRAKE CALIPERS .
- Remove the brake pads from the caliper mounting bracket. Remove and discard the anti-rattle clips from the brake caliper mounting bracket. Inspect the caliper and mounting bracket. See BRAKE CALIPER INSPECTION in DISC BRAKE SYSTEM under ADJUSTMENTS & INSPECTIONS.