LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 187 (Disc Brakes) >> Adjustments & Inspections >> Park Brake System >> Park Brake Shoe Inspection

Park Brake Shoe Inspection

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2003 GMC Savana Special, 2003 GMC Savana Camper Special, 2003 GMC Savana, 2003 Chevrolet RV Cutaway, and 2003 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle.
  2. Remove the tire and wheel.
  3. Remove the rear brake caliper and bracket. See BRAKE CALIPER BRACKETS  under REMOVAL & INSTALLATION.
  4. Remove the rear brake rotor.
  5. Inspect the park brake shoe and lining and replace if any of the following conditions are found:
    • Excessive wear indicated by the park brake lining being worn down to the shoe.
    • Brake lining cracking.
    • Oil or fluid contamination of the brake lining.
  6. Adjust the park brake shoe. See PARK BRAKE ADJUSTMENT  .
  7. Install the rear brake rotor.
  8. Install the rear brake caliper and bracket. See BRAKE CALIPER BRACKETS  under REMOVAL & INSTALLATION.
  9. Install the tire and wheel. Tighten to specification. See TORQUE SPECIFICATIONS  .
  10. Lower the vehicle.
scientia non olet · About LEMON Manuals