Input Shaft Oil Seal Removal

WARNING: This page is about a different car, the 2011 GMC Yukon XL, 2011 GMC Yukon, 2011 Chevrolet Tahoe, 2011 Chevrolet Suburban, and 2011 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Input Shaft Oil Seal

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Input Shaft Oil Seal CAUTION: Refer to Machined Surface Damage Caution . Procedure Drill a pilot hole, as required, and insert a self-tapping screw into the body of the seal. Use a plier or slide hammer type tool to remove the seal from the bore.