Turbine Speed Sensor Installation

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools

J 36850: Transjel® Lubricant

For equivalent regional tools, refer to Special Tools .

Fig 1: VSS & Bolt

Courtesy of GENERAL MOTORS CORP.

Install the vehicle speed sensor O-ring (3) onto the turbine speed sensor (2).
Apply J 36850: lubricant to the O-ring (3).
Install the turbine speed sensor (2) into the transmission case.

CAUTION: Refer to Fastener Caution .

Install the vehicle speed sensor bolt (1) into the transmission case. Tighten the bolt to 12 N.m (108 lb in).