LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1739 (Automatic Transmission - ALLISON - Repair Instructions - Off Vehicle) >> Repair Instructions - Off Vehicle >> Shift Solenoid Valve Assemble

Shift Solenoid Valve Assemble

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools

    Fig 1: Shift Solenoid Screen
    GM1581008Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Transmission Control Valve Body Overhaul Caution .
    NOTE: To help prevent confusing parts on assembly, J-33163:  tray has been used during the disassemble procedure in order to store the removed valves, springs, and stops.
  1. Install the shift solenoid screen (1).
  2. Measure the screen installation depth at dimension A. The screen installed depth is 0.50-1.0 mm (0.020-0.039 in) below the shift valve body surface as shown.
    3. Fig 2: View Of Spring & Control Main Valve
    GM795173Courtesy of GENERAL MOTORS CORP.
  3. Install the control main valve (1) and the control main spring (2).
    4. Fig 3: Compressing Control Main Valve Spring
    GM795171Courtesy of GENERAL MOTORS CORP.
  4. Compress the spring with J-43773:  compressor (2).
  5. Install the retaining clip (1).
  6. Make sure the retaining clip is below the valve body surface.
    7. Fig 4: View Of Plug, Spring & Shift Valve
    GM795170Courtesy of GENERAL MOTORS CORP.
  7. Install shift valve 2 (SV2) (1), spring (2), and plug (3).
    8. Fig 5: Compressing Shift Valve 2 Spring
    GM795169Courtesy of GENERAL MOTORS CORP.
  8. Compress the spring with J-43773:  compressor (2).

    Install the retaining clip (1).

  9. Make sure the retaining clip is below the valve body surface.
    10. Fig 6: View Of Shift Solenoid Shift Valve, Plug & Spring
    GM795166Courtesy of GENERAL MOTORS CORP.
  10. Install shift valve 3 (SV3) (1), the spring (2), and plug (3).
    11. Fig 7: Compressing Shift Valve 3 Spring
    GM795164Courtesy of GENERAL MOTORS CORP.
  11. Compress the spring with J-43773:  compressor (2).
  12. Install the retaining clip (1).
  13. Make sure the retaining clip is below the valve body surface.
    14. Fig 8: Spring & Shift Valve
    GM795163Courtesy of GENERAL MOTORS CORP.
  14. Install shift valve 1 (SV1) (1) and spring (2).
    15. Fig 9: Compressing Shift Solenoid Shift Valve Spring
    GM795162Courtesy of GENERAL MOTORS CORP.
  15. Compress the spring with J-43773:  compressor (2).
  16. Install the retaining clip (1).
  17. Make sure the retaining clip is below the valve body surface.
scientia non olet · About LEMON Manuals