Conditions for Running the DTC
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
P182E
- The engine speed is greater than 400 RPM for 5 seconds.
- The ignition voltage is greater than 8.6 volts.
- Engine torque signal is valid.
- DTCs P0101, P0102, P0103, P0106, P0107, P0108, P0171, P0171, or P0172 are not set.
P1915
- No OSS DTCs P0722 or P0723 and are not Fault Active or Test Fail this Key ON.
- The transmission output shaft speed is less than 90 RPM or less.
- The ignition voltage is between 6.0 volts and 18.0 volts.