Harsh, Soft, Delayed or Slipping Second or Sixth Gear

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Checks	Causes
A/Trans Fluid Pan Assembly (29)	Verify proper fluid level and condition, inspect transmission assembly for leaks.
Control Valve Upper Body Assembly (304)	Inspect for sticking, damaged or worn 2-6 clutch regulator valve (334) and spring (326). Inspect for damaged or sticking #6 ball check valve.
Control Solenoid (w/Body and TCM) Valve Assembly (314)	Pressure Control Solenoid 4 commanded/failed LOW (off) or leaking - Perform solenoid valve assembly function test. Refer to Control Solenoid Valve and Transmission Control Module Assembly Solenoid Performance Test . Incorrect or inadequate adapt activity - Perform Service Fast Learn Adapts procedure.
Center (with 2-6 Low and Reverse Clutch) Support Assembly (67)	Inspect for proper installation of the 2-6 clutch return spring retaining ring (455). Inspect for damaged 2-6 clutch piston assembly (457), spring (456), retaining ring (455), and center support assembly (459). Inspect for worn or damaged 2-6 clutch plates (451-453).
A/Trans Fluid Pump Cover Assembly (219)	Inspect for damaged, stuck, sticky pressure regulator valve (233) and springs (234 and 235). Inspect for damaged, stuck, sticky isolator valve (236) and sleeve (237).
Center Support Fluid Passage Seal Assembly (20)	Inspect for worn, cut, or damaged seals. Inspect for proper seal (20) size (6L45/50E MYA/MYB) vs (6L80/90E MYC/MYD).