LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1733 (Automatic Transmission - 6L45/6L50/6L80/6L90 - DTC P0218 To DTC P0974) >> DTC P0562 or P0563 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the X1 16-way harness connector at the transmission.
  2. Connect the DT-47825-10:  harness to the X1 16-way vehicle harness connector.
  3. Test for less than 5 ohms between terminal 5 and ground at the transmission case.
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  4. Ignition ON, verify that a test lamp illuminates between the ignition voltage circuit and B+ circuit terminals listed below and ground.
    • Terminal 4 and ground at the transmission case
    • Terminal 12 and ground at the transmission case
    • If the test lamp does not illuminate, test the ignition circuit or B+ circuit for a short to ground or an open/high resistance.
  5. If all circuits test normal, replace the Q8 control solenoid valve assembly.
scientia non olet · About LEMON Manuals