Torque Dampener Housing and Fluid Pump Cover Installation

WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Torque Dampener Housing & Fluid Pump Cover Tightening Sequence

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	A/Trans Torque Dampener Housing Gasket Tip: Do not reuse the gasket. Replace with a NEW gasket.
2	A/Trans Torque Dampener (w/Fluid Pump) Housing Assembly
3	A/Trans Fluid Pump Cover Bolt M8 x 1.25 x 25 (Qty: 12) CAUTION: Refer to Fastener Caution . Procedure:: Tighten in the sequence shown. Tighten: 24-29 N.m (17.70-21.38 lb ft)