Torque Dampener Housing Removal

WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Torque Dampener Housing

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
CAUTION: The valve body assembly must be removed prior to removing the torque dampener (with fluid pump) housing assembly. Failure to ensure this will cause severe damage to both fluid pump seal assemblies. Also, the load of the valve body pushing on the seals, which in turn push on the pump, may prevent proper pump installation into the case. Refer to control valve body assembly removal.
1	A/Trans Fluid Pump Cover Bolt M8 x 1.25 x 25 (Qty: 12)
2	A/Trans Torque Dampener (w/Fluid Pump) Housing Assembly
3	A/Trans Torque Dampener Housing Gasket