Holding Fixture Installation and Torque Dampener Removal

WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Holding Fixture & Torque Dampener

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	A/Trans Torque Dampener Assembly Special Tool: J 21366 Converter Holding Strap
2	A/Trans Case Assembly Procedure Rotate the transmission so that the dampener housing is up and secure with locking pin. Allow any remaining transmission fluid to drain from the case extension. Special Tools DT-48307 Holding Fixture. See Special Tools . J 3289-20 Holding Fixture Base Assembly. See Special Tools .

Callout

Component Name

A/Trans Torque Dampener Assembly
Special Tool:
J 21366 Converter Holding Strap

A/Trans Case Assembly

Procedure

Rotate the transmission so that the dampener housing is up and secure with locking pin.
Allow any remaining transmission fluid to drain from the case extension.

Special Tools

DT-48307 Holding Fixture. See Special Tools .
J 3289-20 Holding Fixture Base Assembly. See Special Tools .