Valve Assembly and Transfer Plate Disassemble

WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Valve Assembly & Transfer Plate

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Control Valve Channel Plate Bolt M6 x1.0 x 35 (Qty: 3)
2	Control Valve Channel Plate Bolt M6 x 1.0 x 35.0 (Qty: 17)
3	Control Valve Channel Plate Tip: Separate the upper and lower valve bodies by carefully prying at the point indicated.
4	Control Valve Body Spacer (w/Gasket) Plate Assembly CAUTION: Do not use the old spacer plate. Install a NEW spacer plate. Reusing an old spacer plate may cause internal transmission leaks and transmission damage.
5	A/Trans Fluid Pump Ball Check Valve Tip: Remove only 1 ball check valve. There are 2 incapsilated ball check valves. Do not remove. Note the position of the ball check valves.
6	Control Valve Upper Body Assembly