Valve Assembly to Transfer Plate Assemble
WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
| Callout | Component Name |
|---|---|
| 1 | A/Trans Fluid Pump Ball Check Valve Tip: Clean and inspect the ball check valve and install. Refer to Ball Check Valve Locations . |
| 2 | Control Valve Body Spacer (w/Gasket) Plate Assembly
CAUTION:
Do not use the old spacer plate. Install a NEW spacer plate. Reusing an old spacer plate may cause internal transmission leaks and transmission damage.
|
| 3 | Control Valve Channel Plate Tip: Turn the valve body assembly over after installing to the upper body. |
| 4 | Control Valve Channel Plate Bolt M6 x1.0 x 35 (Qty: 3) Tip: Hand tighten only. |