Removal Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Oil Pressure Sensor Electrical Connector

Courtesy of GENERAL MOTORS CORP.

NOTE: Clean the area around the sensor. Do not allow debris to enter the engine.

Remove the left wheelhouse inner panel. Refer to Front Wheelhouse Liner Replacement - Left Side (Chevrolet) or Front Wheelhouse Liner Replacement - Left Side (GMC) .
Disconnect the oil pressure sensor electrical connector.

Fig 2: View Of Oil Pressure Sensor

Courtesy of GENERAL MOTORS CORP.

Using DT-48827 , remove the oil pressure sensor (1). See Special Tools .